Average Reviews:
(More customer reviews)I am not an Engineer, but this unit appears to have two major problems. First, to collect fine dust from room air, it seems the less turbulence in the air the more efficient the unit. The air should flow directly from the dust source to the fiter. The discharge from this unit when at high speed, can be felt 20-25 feet away. This creates tremendous air turbulence and reduces its ability to suck dust-filled air from all parts of the room. The discharge air from the unit should have been better distributed back into the room. I added a plastic sheet deflector to redirect the air 90 degrees to each side and 90 degrees the ceiling rafters, and it works better.
Secondly, the remote control sensor for the air filter is mounted on the discharge end of the unit. Think about it. If you mount the filter at the end of your workshop to suck the air all in one direction, you would then want the intake to be facing the center of the workshop. If you do that, you will then have to walk to the other end of the unit in order to use the remote control. I think the sensor is infra-red, and it must be aimed exactly at the target. This is backward. It should be mounted on the intake side.
The unit is relativly quiet, and it does remove a considerable amount of dust from the air.
Click Here to see more reviews about: JET 708614 AFS-1500 750/900/1300 CFM 3 Speed Air Filtration System
Jet 708614 AFS-1500 Air Filtration System with Remote Control, 3-Speed, 1500 CFM
Get 19% OFF
No comments:
Post a Comment